GENUINE Blur 150, Руководство по обслуживанию

Страница: 89 / 186

INSPECTION
Check the following parts for damage and clogging.
* Pilot jet * Piston valve
* Main jet * Starter jet
* Main air jet * Gaskets and O-rings
* Pilot air jet No.1 & No.2 * Pilot outlet and bypass
* Needle jet holder * Coasting enrichement valve
* Float * Needle valve
* Jet needle * Valve seat
if any abnormal condition is found, wash the part clean. If
damage or clogging is found, replace the part with a new
one.
CARBURETOR CLEANING
!WARNING
Clean all jets with a spray-type carburetor cleaner and
dry them using compressed air.
Clean all circuits of the carburetor thoroughly-not just the
perceived problem area. Clean the circuits in the
carburetor body with a spray-type cleaner and allow each
circuit to soak, if necessary, to loosen dirt and varnish.
Blow the body dry using compressed air.
!CAUTION
after cleaning, reassemble the carburetor with new seals
and gaskets.
Some carburetor cleaning chemicals, especially
diptype soaking solutions, are very corrosive and
must be handled carefully. Always follow the chemi-
cal manufacturer’s instructions on proper use, han-
dling and storage.
Do not use a wire to clean the jets or passageways.
A wire can damage the jets and passageways, if
the components cannot be cleaned with a spray
cleaner it may be necessary to use a dip-type clean-
ing solution and allow them to soak. Always follow
The chemical manufacturer’s instructions for proper
use and cleaning of the carburetor components.