Gentherm CCSS, Руководство пользователя

Страница: 4 / 21

USER GUIDE CopyRIGht © 2012 GENthERM
3
•
Reorient or locate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
•
The Climate Control Sleep System utilizes 110/220 V, 50/60Hz,
2A
•
Manufactured by Gentherm
•
Electronics made in China
•
For household/residential use only.
FCC Compliance
The remote device complies with part 15 of the FCC rules. Opera-
tion is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must not accept any
interference received, including interference that may cause unde-
sired operation.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection
against harmful interference with a residential installation. This
equipment generates, uses and can radiate frequency energy and,
if not installed and used in accordance with these instructions, may
cause harmful interference to radio communications. There is no
guarantee that interference will not occur in a particular situation.
If this equipment does interfere with TV or radio reception, which
can be determined by turning the device on and then off, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Modifications made to the product, unless expressly approved by
Gentherm, could void the user’s authority to operate the equipment.
CAUTION : Exposure to Radio Frequency Radiation. Antenna shall be
mounted in such a manner to minimize the potential for human contact
during normal operation. The antenna should not be contacted during
operation to avoid the possibility of exceeding the FCC radio frequency
exposure limit.
The Climate Control Sleep System conforms to UL Standard 962 test
requirements.