Page: 13 of 18
Copyright © 2017 GenTent® Safety Canopies, LLC – All Rights Reserved V6.6.2–November, 2017
Select and Install Electrical apron
-
If your electrical outlets are on the short side of the generator, select
the short Electrical apron; otherwise select the long Electrical apron.
Only use one skirt!
-
Flip the canopy over flap up from corner to corner on the side that is
over the electrical outlets (fig. 6-C).
-
The left and ride sides of the Electrical apron are angled upward
slightly as compared to the main body of the skirt. The angle starts
about 6 inches from either side and this
corresponds to the respective
corner
of the GenTent. Press either corner on first (fig. 6-C), then
wrap the 6-inch section onto the adjacent side of the electrical panel
and press firmly. Now press the main skirt body over the electrical
panel to the other corner, and then wrap that edge around the
adjacent side and press firmly in place.
-
Flip the over flap down and over the Electrical apron (fig. 6-D).
Fig. 6-C
Fig. 6-D
Note: The intent of the Electrical apron is to cover the
electrical outlets in the front
and
about 6”
around the
adjacent sides
. Do not cover other parts of your generator
with the Electrical aprons, especially the exhaust area!
