Page: 8 of 18
Copyright © 2017 GenTent® Safety Canopies, LLC – All Rights Reserved V6.6.2–November, 2017
-
Push
clamp opening straight onto frame (fig. 3-A). The clamp will pop over the frame.
If rubber sleeve used, slide clamp up and over (fig. 3-B).
Do not over extend the mouth
of the clamp!
- Position clamp diagonally from sides of the generator frame (fig. 3-C);
- Tighten knob, centered on washer until clamp is firmly in place. This usually requires
only 2 full turns once the knob/washer seat to the clamp body.
Clamp strength is
reduced by over-tightening as the clamp mouth pulls away from the frame.
- Repeat procedure on remaining three sides; position clamps at the same height.
Fig. 3-A
Fig. 3-B
Fig. 3-C
