BRAIN 17
33
732788 - Rev. A_1
ENGLISH
6.2.1 REMOTE MEMORISATION OF
RC
RADIO CONTROLS
With RC radio controls you can remotely memorise other radio controls, i.e. without working directly
on the board, using a previously memorised radio control.
1. Take a radio control that has already been memorised on one of the 2 channels (OPEN A or OPEN
B/CLOSE) and move to the vicinity of the board.
2. Simultaneously press and hold P1 and P2 until both LEDs flash slowly for 5 sec.
3. Within 5 seconds, press the previously memorised radio control button to activate the learning phase
for the selected channel.
4. The LED on the board corresponding to the channel in learning mode will flash for 20 sec within which
another radio control code is transmitted by pressing the button.
• The corresponding LED on the board will go on steady for 2 sec (indicating that memorisation has
been completed) and will begin flashing again for another 20 sec, during which you can memorise
other radio controls, and will finally go off.
6.3 DELETING THE RADIO CONTROLS
This operation CANNOT be reversed. This will delete ALL the radio control codes me-
morised as both OPEN A and OPEN B/CLOSE. The cancellation procedure is active only
in gate status visualisation mode.
1. Press and hold -/R2
-/R2
.
• After pressing for about 5 sec, the DL12 LED begins to flash slowly; after another 5 sec of slow
flashing and holding, the LEDs DL11 and DL12 begin flashing more rapidly (cancellation has started).
•
Once rapid flashing has stopped, LEDs DL11 and DL12 will go on steady, confirming the cancellation
of all the radio codes (OPEN A and OPEN B/CLOSE) from the board memory.
2. Release -/R2
-/R2
. The LEDs will go off, indicating correct cancellation.
Содержание Brain 17
Страница 1: ...BRAIN 17 BRAIN 17...