Genie S-80 XC, Руководство оператора

Страница: 40 / 73

Operator's Manual First Edition • Second Printing
Inspections
38 S
®
-80 XC
™
• S
®
-85 XC
™
Part No. 1279298GT
Test Limited Drive Speed
40 Press down the foot switch.
41 Raise the boom approximately 15° above
horizontal.
42 Slowly move the control handle to full drive
position.
Result: The maximum achievable drive speed
with the boom raised should not exceed
22 cm/s.
43 Lower the boom to the stowed position.
44 Extend the boom 46 cm.
45 Slowly move the control handle to full drive
position.
Result: The maximum achievable drive speed
with the boom raised should not exceed
22 cm/s.
If the drive speed with the boom raised or
extended exceeds 22 cm/s, immediately tag
and remove the machine from service.
Test Drive Tilt Cutout
46 Press down the foot switch.
47 With the boom fully stowed, drive the machine
onto a slope where the machine pitch angle is
greater than 7° (front to back).
Result: The machine should continue to drive.
48 Return the machine to level ground and extend
the boom approximately 46 cm.
49 Drive the machine onto a slope where the pitch
angle is greater than 7° (front to back).
Result: The machine should stop once the
machine reaches 7° of chassis tilt and the
alarm should sound at the platform controls.
50 Retract the boom to the stowed position.
Result: The machine should drive.
51 Return to level ground and raise the boom to
approximately 15° above horizontal.
52 Drive the machine onto a slope where the pitch
angle is greater than 7° (front to back).
Result: The machine should stop once the
machine reaches 7° of chassis tilt and the
alarm should sound at the platform controls.
53 While on the slope, attempt to raise and extend
the boom.
Result: The boom raise and extend functions
should not operate.
54 Lower the boom to the stowed position.
Result: The machine should drive.