Sharp and SharpX CAT5E cables
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016
93
4 Insert the wires into the EZ-RJ45 connector according to TIA/EIA-568-B.1-2001 specification, using
the appropriate
conductor arrangement for Sharp (T568A) or SharpX (T568B)
TIP:
The EZ-RJ45 allows the conductor wires to pass all the way through the connector for easy
field crimping. You can insert the wires all at once if you choose, but you may find it easier to
insert them one at a time.
5 Make sure the wire ends on the connector’s pin side are in the correct order before you continue.
NOTE:
If you crimp the cable with the wires in the wrong order, you will need to cut the connector
off and begin the process again.
6 After you have inserted the wires into the EZ-RJ45 connector, twist the CAT5e wires together, and
then pull them through the connector until the copper tape is inside the connector as well.
Make sure to adjust the strain relief boot so it is in the proper position.
7 Insert the EZ-RJ45 connector into the corresponding slot on your EZ-RJ45 crimp tool, and then
firmly squeeze the handles together.
The crimp tool should trim the wire ends, but you can trim them further to make sure they are
flush with the connector’s surface.
