AutoVu SharpX mobile installation
tip.genetec.com | AutoVu Hardware Guide for SharpX Mobile Installation
EN.410.018-XS(6) | Last updated: October 6, 2016
37
Connecting the camera cable to the LPR Processing Unit
When connecting SharpX cameras, you need to connect the camera cable to the LPR Processing Unit.
The power, data, and video wires for the camera cable are contained inside the SharpX all-in-one
cable.
Before you begin
• Run the camera cable from the camera location to the LPR Processing Unit.
• Shorten the cable as required (make sure to leave some slack for maintenance purposes).
To connect the camera cable to the LPR Processing Unit:
1 Connect the 5-pole connector to the camera port, and then tighten the securing screws.
2 Strip 20 cm (8 in.) of the all-in-one cable’s jacket to expose the wires inside.
•
A
: All-in-one cable
•
B
: Camera wires
•
C
: CAT5e cable
3 Trim the polyester fill threads and aluminum foil as needed.
4 Shorten the camera cable by about 5 cm (2 in.). This is needed because the CAT5e cable will also
be shortened by about 5 cm (2 in.) when you crimp the RJ45 connector.
5 Strip 10 mm (3/8 in.) of insulation from the camera wires (the drain wire has no insulation).
