En-8
HI-POWER OPERATION
Example:
When set to COOL.
Note that the hi-power operation will be
automatically cancelled under the
following conditions.
●
During heating operations:
When the room temperature exceeds
the temperature setting by 2
°
C.
●
During cooling and dry operations:
When the room temperature is 1
°
C
lower than the temperature setting or
when hi-power has been in operation
for more than 30 minutes since it was
set.
●
During fan operation:
When hi-power has been in operation
for more than 15 minutes since it was
set.
Airflow direction and fan speed are set
automatically during hi-power operation.
However, the air flow direction can be
changed to a desired position by using
the airflow direction button. (Refer to page
11.)
●
Start this operation after starting the operation of the unit.
To operate Hi-power
1
Start the operation in any one of the following: AUTO,
COOL, HEAT, DRY or FAN.
Refer to pages 5 and 6 for information about starting these operations.
2
Press the HI-POWER button. (Fig. 5
X
)
The indicator lamp for hi-power (red) will light up.
To stop Hi-power
Press the HI-POWER button.
●
The indicator lamp for hi-power (red) will go out.
●
The unit will return to normal operation.
Hi-power operation
Heating
:
●
If the hi-power button is pressed immediately after starting op-
eration, the unit will enter the “downward airflow operation” for
15 minutes so that heating of low areas near the floor will be
performed at the highest power.
●
After this time has been completed, the airflow direction will
change automatically so that the entire room can be heated evenly.
Cooling, Dry :
●
Operates at maximum fan power until 1
°
C before the setting tem-
perature and rapidly cools the room.
Fan
:
●
Increases the fan speed of the indoor unit.
Все каталоги и инструкции здесь:
http
:
//splitoff.ru/tehn-doc.html