En-12
SWING OPERATION
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING LOUVER button (Fig. 5
W
).
The SWING Indicator Lamp (orange) (Fig. 3
9
) will light.
In this mode, the Air Flow Direction Louvers will swing automatically to direct the
airflow both up and down.
To Stop SWING Operation
Press the SWING LOUVER button (Fig. 5
W
) once again.
The SWING Indicator Lamp (orange) (Fig. 3
9
) will go out.
Airflow direction will return to the setting before swing was begun.
About Swing Operation
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 3
I
) on the main unit
control panel.
To stop operation, press the MANUAL AUTO button once again.
(Controls are located inside the Intake Grille.)
●
When the air conditioner is operated
with the controls on the Main Unit, it
will operate under the same mode as
the AUTO CHANGEOVER mode se-
lected on the Remote Control Unit (see
page 6).
●
During MANUAL AUTO operation, the
thermostat is automatically set at a
standard temperature setting (=24
°
C).
●
The fan speed selected will be “AUTO”
and the airflow direction will be the
standard direction (cooling:
1
, heat-
ing:
6
).
●
If the operation does not start when the
MANUAL AUTO button is pressed
once, it is because the air cleaning
check function is operating. Press the
button once more to start operation.
Example:
When set to 26
°
C.
During cooling/Dry mode : Swings between
1
and
3
.
During heating mode
: Swings between
3
and
7
.
●
The SWING operation may stop temporarily when the air conditioner’s fan is not
operating or when operating at very low speeds.
●
The airflow direction can not be adjusted during SWING operation even when
the AIR FLOW DIRECTION button is pressed.
Большая библиотека технической документации
http://splitoff.ru/tehn-doc.html
каталоги, инструкции, сервисные мануалы, схемы.