En-7
AIR CLEANING OPERATION
Example:
When set to AUTO.
●
Use this function to remove airborne impurities such as dust, tobacco smoke and pollen and clean the air of the room.
●
The air cleaning operation can be used alone or combined with cooling, heating and dry (dehumidifying) operations.
Starting air cleaning operation
1
Start the operation in any one of the following: AUTO,
COOL, HEAT, DRY or FAN.
Refer to pages 5 and 6 for information about starting these operations.
2
Press the AIR CLEAN button. (Fig. 5
Y
)
The indicator lamp for the clean air indicator will light up.
Stopping the air clean operation
Press the AIR CLEAN button.
The indicator lamp for the clean air indicator will go out.
About the clean air indicator
●
The level of airborne contaminants in the room is monitored by the clean air indicator sensor
(Fig. 1
F
) and displayed in the clean air indicator. When the air is clean, all the clean air
indicator lamps will be green. As the air becomes dirty, the number of red indicator lamps will
increase.
●
After the power supply plug has been plugged in and the air cleaning operation has started, the clean air indicator sensor
will perform a preparation operation for approximately 3 minutes. (The same will occur when more than 6 hours have
passed after the operation has been stopped by the remote controller.) At this time, the sensor does not monitor the level of
airborne contaminants and the clean air indicator lamps will all be green. After 3 minutes of operation, the sensor will begin
to monitor the airborne contaminants and the condition of the air in the room will be displayed.
●
When the air cleaning operation is being performed, the number of illuminated red indicator lamps will either increase or
decrease according to the condition of the air in the room and the operation of the remote controller.
●
The clean air indicator does not respond to some contaminants.
Response by clean air indicator
: Tobacco smoke, incense, aerosol sprays (insect sprays, cosmetic sprays), alcohol
(beverages, cooking, etc.), water vapor (from kitchen or bathroom) and others.
No response by clean air indicator
: Dust, pollen, mold spores, mite particles and others.
Air cleaning
●
During operation the unit produces a small amount of ozone that can be smelled.
●
When this unit is used in combination with the dust collection unit, white particles will become attached to the dust collec-
tion unit. When this happens, clean the dust collection unit as soon as possible. (Refer to page 14.)
●
The air cleaning unit cannot remove gases such as carbon dioxide and alcohol from the air. During operation, ventilate the
room often to prevent asphyxiation or suffocation.
●
If the intake grille is opened during operation, a safety device will stop the operation of the air cleaning unit. When this
happens, the operation lamp (red) on the main unit will and the timer lamp (green) will flash and the temperature monitor
will display
. Use the START/STOP button on the remote controller to stop the operation, close the grille and then use the
START/STOP button to restart the operation.
●
Use the FAN CONTROL button to change the fan speed. (Refer to page 5.) The air cleaning unit operates most effectively at
the highest fan speed.
●
When the fan is set to automatic, the fan speed will change among three fan speeds in response to the output of the clean
air indicator. When the air in the room becomes clean, the air cleaning operation will be performed at the lowest fan speed.
●
The clean air indicator will flash to inform you that the periodic cleaning of the dust collection unit is required. (Refer to Air
Clean Check Function, page 14.)
ROOM
TEMP.
CLEAN
AIR
POLLUTED
AIR
OPERATION
TIMER
SWING
AIR CLEAN INDICATOR
HI-POWER
Clean air indicator
Все каталоги и инструкции здесь:
http
:
//splitoff.ru/tehn-doc.html