General 90-170B M1, Руководство по установке и эксплуатации, Страница: 22 / 32

22
PERIODIC MAINTENANCE & LUBRICATION
LUBRICATION
PERIODIC MAINTENANCE
ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE PERFORMING ANY LUBRICA-
TION OR MAINTENANCE.
B
NEVER OPERATE THE BANDSAW WITH ANY DAMAGED PART. REPLACE A DAMAGED PART AT THE FIRST VIS-
IBLE SIGNS OF DAMAGE.
1. Inspect/test the ON/OFF switch before each use. Do not operate the bandsaw with a damaged switch; replace
a damaged switch immediately.
2. Periodically inspect the power cord/plug and the blade for damage.
3. Keep the machine clean and free of sawdust. Frequently blow out or vacuum up the sawdust and wipe down
the machine occasionally with a damp rag.
Note: The wheels must always be kept clean. Dirt on the wheels will cause blade slippage.
4. Do not allow dirt, pitch or gum to build up on the table, blade, guide/thrust bearings. Clean as needed with
gum and pitch remover.
Note: Do not immerse the bearings in the gum and pitch remover.
5.
To prevent rust from forming on the unpainted cast iron of the table, and so that the wood slides easily while
cutting, apply a light coating of paste wax or use regular applications of any after-market surface protectant
or rust inhibitor.
TO AVOID EYE INJURY FROM BLOWING DEBRIS, WEAR SAFETY GOGGLES WHEN BLOWING OUT SAWDUST.
C
Keep the rack and pinion A , blade tension adjustment screw B , as well as the table trunnion C , well greased and
free of dust or debris.
Clean and remove dust, debris, and old grease after every 10-15 hours of use. After cleaning, reapply grease as
needed. (Use any all purpose grease.)
The motor and all bearings are sealed and permanently lubricated – no further lubrication is required. No other
part of this bandsaw needs lubrication.
A