General 90-170B M1, Руководство по установке и эксплуатации, Страница: 13 / 32

13
1. Loosen lock knobs C (below) and lock knob B (right)
located under the saw table.
2. Tilt the table until it is at the desired angle. (Refer to the
angle indicator
A .)
3. Tighten the lock knobs to lock the table in position.
TILTING THE TABLE
The table can be tilted to any angle from 0° to 45° to the
right to allow for any type of bevel (or angle) cutting. Refer
to the table tilt angle indicator
A located under the band-
saw table, to set the angle of the table to the desired posi-
tion.
BEFORE MAKING ANY ADJUSTMENTS, MAKE SURE
THAT THE SWITCH IS IN THE “OFF” POSITION AND
THAT THE POWER CORD IS UNPLUGGED.
ADJUSTING THE 90º TABLE STOP AND RE-ALIGNING THE ANGLE POINTER
To ensure that your 90º cuts are square and that angled cuts are accurate with the angle indicator scale, the table
default position must be set to 90º to the blade and the angle indicator pointer must be set to read 0 when the table
is in the default (90º) position. To set the table-stop bolt:
C
D
1. Loosen lock knobs C and lock knob B.
8. With the table set to 90º and the stop bolt at the
correct height, make sure the table tilt angle indi-
cator pointer
I is set to read 0º.
9. If the pointer needs to be adjusted, loosen the
screw
J on the pointer of the front trunnion and
adjust the pointer K to the 0 point on the scale.
Then re-tighten the screw to secure the pointer in
place.
J
2. Place a combination square D flat on the table
with the heel of the square flat against the saw
blade
E .
3. Level the table until it is exactly 90° to the blade,
then tighten lock knobs
C and B .
E
I
F
H
A
B
4. Using the supplied open end wrench, loosen the
jam nut
F on the 90º table-stop bolt then adjust the
height of the bolt G until it touches the underside of
the table as shown in H .
5. Loosen the lock knobs B and C and make sure the
table is resting on the table-stop bolt H .
6. Check the square and make sure the table is still at
90° to the blade. If not, re-adjust the table-stop bolt.
7. Re-tighten jam nut F .
F
G
You will now be able to accurately return the table to the 90º position automatically without further adjustments and
scale reading for any angle other than 0 will also be accurate.
K