General 90-170B M1, Руководство по установке и эксплуатации, Страница: 10 / 32

ATTACHING THE TABLE
The worktable mounts on a bracket which allows
adjustment from flat (0°) to any angle up to 45° to the
right. Adjustments can be made easily with the angle
scale and lock knobs.
1. Remove the red insert A from the center of the
table and the table alignment pin B from the
table slot.
The protective coating on the saw table prevents rust from
forming during shipping and storage. Remove it by rub-
bing with a rag dipped in kerosene, mineral sprits or paint
thinner. (Dispose of potentially flammable solvent-soaked
rags according to manufacturer’s safety recommenda-
tions.)
A putty knife, held flat to avoid scratching the surface, may
also be used to scrape off the coating followed by clean-
up with solvent. Avoid rubbing the saw’s painted surfaces,
as many solvent-based products will remove paint.
To prevent rust, apply a light coating of paste wax or use
regular applications of any after-market surface protectant
or rust inhibitor.
CLEAN UP
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE SAW TO THE POWER SOURCE BEFORE YOU HAVE
COMPLETED THE INSTALLATION AND ASSEMBLY STEPS.
DO NOT CONNECT THE SAW TO THE POWER SOURCE UNTIL INSTRUCTED TO DO SO.
Tip: With a screw driver, push a solvent-saturated rag into
the T-slots to remove the grease so the miter gauge will
slide freely.
ASSEMBLY INSTRUCTIONS
This model 90-170B is supplied with convenient
onboard storage brackets to safely stow the rip fence
and miter gauge out of the way when not in use
A .
Attach the rip fence storage bracket B and miter
gauge storage brackets C to the back of the saw as
shown in D , using the bolts and washers already
mounted to the saw.
ATTACH THE STORAGE BRACKETS
For your convenience this bandsaw is shipped from the factory partially assembled and requires only minimal
assembly and set up before being put into service.
B
C
D A
2. Turn the table right side up. Verify that the long bolts
C in the center of each trunnion are pointing down.
3. Carefully move the table into position over the
table-tilt bracket
D , guiding the saw blade through
the table slot E.
C
D
E
A
B
10