General 90-170B M1, Руководство по установке и эксплуатации, Страница: 11 / 32

N
N
M
6. Thread the two small lock knobs H onto the long
bolts I now protruding from the underside of the
table-tilt bracket and tighten loosely.
7. Attach the table tilt support bracket J to the rear of
the saw using the big lock knob K with the two flat
washers L already mounted on the frame.
I
H
L
K
J
F
G
G
4. Rotate the table 1/4 turn counterclockwise so that the
saw blade is now perpendicular to the table slot
F .
5. Gently lower the table onto the bracket so the long
bolts
C in the center of the trunnions pass through
the holes in the table-tilt bracket G .
O
P
9. Re-install the insert into the center of the table, with
the opening in the slot
O facing the rear of the saw.
10. Re-install the table alignment pin into the table
slot
P .
8. Make sure that the blade is centered in the table
opening. If the blade is not centered, slide the ta-
ble back or forward
M until the blade is centered in
the table opening, then fully tighten the two lock
knobs,
H .
INSTALL THE FOOT BRAKE
1. Open the lower wheel cover door.
2. Attach the foot brake to the foot brake mounting bar
as shown in
Q using the two supplied cap screws and
lock washers, in the assembly order shown in R .
3. Firmly tighten with the supplied 8 mm Allen key.
Note: If the long bolts have moved out of position, have
an assistant tap them into place with a screw driver.
R
INSTALL THE FENCE ASSEMBLY
This model 90-170B M1 is equipped with an Excalibur T-
fence and guide rail system.
Follow all assembly and adjustment instructions in the 90-
075A manual supplied in the box with the Excalibur
Universal Bandsaw Rip Fence System.
11
Q