General 90-125 M1, Руководство по установке и эксплуатации, Страница: 12 / 42

12
1. Remove the red insert from the center of the table
and the table alignment pin from the table slot.
2. Turn the table right side up. Verify that the long bolts
in the center of each trunnion are pointing down. (See
Fig. 9)
3. Carefully move the table into position over the table-tilt
bracket, guiding the saw blade through the table slot.
(See Fig. 7)
4. Rotate the table 1/4 turn counter-clockwise so that the
saw blade is now perpendicular to the table slot. (See
Fig. 8)
5. Gently lower the table onto the bracket so the long
bolts
in the center of the trunnions pass through the
holes in the table-tilt bracket.
Note: If the long bolts have moved out of position, have an
assistant tap them into place with a screw driver.
6. Thread the two lock knobs onto the long bolts now
protruding from the underside of the table-tilt brack-
et and tighten loosely. (See Fig. 9)
7. Make sure that the blade is centered in the table open-
ing
. If the blade is not centered, slide the table back
or forward until the blade is centered in the table
opening. Then tighten the six combination head bolts
and the two hex bolts and . (See Fig. 10)
7. Re-install the red insert to the center of the table, with
the opening in the slot facing the rear of the saw. (See
Fig. 11)
8. Re-install the table alignment pin into the table slot.
ATTACHING THE TABLE
Fig. 7 Fig. 8
Fig. 9
UNDERSIDE VIEW OF TABLE
Fig. 10
Fig. 11