General 90-125 M1, Руководство по установке и эксплуатации, Страница: 10 / 42

1. Remove the door knob assembly from inside the ba-
se cabinet where it is stored for shipping
.
2. From the inside, insert the door bolt through the ho-
le in the door, into the door knob
.
3. Tighten the door bolt.
ASSEMBLY INSTRUCTIONS
Serious personal injury could occur if you connect the machine to the power source before you have completed
the installation and assembly steps. DO NOT connect the machine to the power source until instructed to do so.
For your convenience this bandsaw is shipped from the factory partially assembled and requires only minimal
assembly and set up before being put into service.
ATTACHING THE DOOR KNOB
INSTALL THE BANDSAW ONTO THE BASE CABINET
The bandsaw is mounted onto a base cabinet, which provides storage space for the miter gauge and replacement
blades.
The bandsaw is heavy. Do not over-exert. The help of an assistant will be needed for the following step.
Do not grip the bandsaw by the lower wheel cover door when lifting. Keep hands away from blade at all times.
1. Position the bandsaw over the four holes on top of the base
cabinet .
2. Insert four hex head bolts and flat washers down through the
holes in the legs of the bandsaw and into the base cabinet. Then
open the door and from the inside, tighten four hex nuts with wa-
shers
onto the bolts, using a 12 mm open end wrench and
12 mm socket.
Note: To be able to insert the hex
head bolt down through the hole
under the motor, you must first pivot
the motor to the left.
Proceed as follows:
At the back of the bandsaw, just
above the motor, there is a ratchet
lever
.(See Fig. 3).
Pull it out as in Fig. 3, then pull up on
the capacitor cover of the motor
to pivot it to the left. (See Fig. 4).
Fig. 4
Fig.3
10