General 90-125 M1, Руководство по установке и эксплуатации, Страница: 11 / 42

Thread the tension lever onto the tension lever seat .
INSTALLING THE TENSION LEVER HANDLE
ATTACHING THE TABLE-TILT BRACKET
The work table mounts on a bracket which allows adjust-
ment from flat (0°) to any angle up to 45° to the right.
Adjustments can be made easily with the angle scale and
lock knobs.
1. Remove the two hex bolts and , and their washers
from the lower wheel housing. (Fig. 5)
See Fig. 6
2. Place the table-tilt bracket on the lower wheel housing
and align holes
and to the threaded holes in the
lower wheel housing (hole is not used).
3. Place washers on the two hex bolts and and in-
sert the bolts through the table-tilt bracket holes and in-
to the threaded holes in the lower wheel housing.
4. Tighten loosely* , using a 12 mm open end wrench
and 12 mm socket.
5. Thread a nut onto the longer table-stop bolt and
screw the bolt into the hole on the rear tab of the table
tilt bracket.
* Final tightening will be done after centering the table
opening with the blade.
The dust port has a 2 –1/2" opening to accommodate con-
nection to a dust collector (not included). Install the dust
outlet on the right side of the bandsaw as follows:
1. Remove the two hex bolts and washers from the dust
port , using a 10 mm open end wrench.
2. Open the lower wheel cover door by pulling the yel-
low knob .
3. Align the 2 holes in the dust port with the 2 holes on
the edge of the door
, and insert bolts with wa-
shers through the inside of the door, into the dust port,
and tighten
.
ATTACHING THE DUST PORT
LOWER WHEEL HOUSING
Fig. 5
Fig. 6
LOWER WHEEL COVER DOOR
NOT USED
TABLE-TILT BRACKET
11