The mortiser is equipped with a rocker style ON/OFF dust-proof switch located on the front left hand side of the mor-
tiser head.
-
To start the mortiser, push on the upper portion of the switch
;
-
To stop the mortiser, push on the lower portion of the switch
.
ON/OFF POWER SWITCH
VERIFY ALL FOLLOWING CHECK POINTS BEFORE
TURNING ON THE MORTISER. FAILURE TO COMPLY
CAN RESULT IN SERIOUS INJURIES.
BASIC OPERATIONS
1.
Layout and mark workpieces for the mortises to be
cut.
2.
Install the appropriate chisel and bit in the chuck.
3.
Place the stock on the table against the fence
.
4.
Set the depth stop.
5.
Loosen the fence locking levers
and adjust the
fence until the workpiece is positioned with the
mortise to be cut centered on the chisel
.
NOTE: If necessary, lower the chisel onto the workpiece to
make sure the layout lines of the mortise are aligned with
the bit.
Transfer a reference line showing the desired depth of cut onto the front face of the workpiece and then set the
depth stop as follows:
SETTING THE DEPTH STOP
1.
Lower the chisel to the bottom of your depth refe-
rence line
then adjust the depth stop
against the stop plate
as shown to prevent the
chisel from lowering any further.
NOTE: As a time saving convenience, the upper stop
can be set to control the upward travel of the head. This
feature allows you to save time by raising the bit only
enough to clear the workpiece and allow you to reposition
the workpiece without having to raise the head to its ma-
ximum.
13
CLOSE UP
•
MAKE SURE THE TWO SLIDE PLATES OF THE CHUCK COVER
ARE CLOSED AND THEIR LOCK KNOBS ARE TIGHTENED
SECURELY.
•
MAKE SURE THE CHISEL AND BIT ARE PROPERLY INSTALLED
AND THAT THE BIT CHUCK AND CHISEL LOCK LEVER ARE
TIGHTENED SECURELY.
•
WHEN THE MORTISER IS RUNNING CHECK TO SEE IF IT RUNS
WITHOUT VIBRATION OR SHAKING
.
Содержание 75-050T M1
Страница 21: ...21 Notes ...
