General International 15-030 M1, Руководство по установке и эксплуатации

Страница: 13 / 29

CONVEYOR MOTOR SWITCH WITH SAFETY KEY
SAFETY KEY* ON
*
PREVENTS START-UP WHEN REMOVED
OFF
This model 15-030 is also equiped with a simple ON/OFF
switch for the conveyor motor, featuring a removable
lock out safety key.
To start the conveyor belt, insert the safety key, , and
lift the switch up, . To stop the machine, push the
switch down, .
To prevent unauthorized use or unintentional start-up,
remove the safety key and store it in a safe place
whenever the sander is not in use.
REMOVE THE SWITCH KEY AND STORE IT IN A SAFE PLACE, OUT OF THE REACH OF CHILDREN, WHENEVER THE SANDER IS
NOT IN USE.
OVERLOAD PROTECTION
The magnetic safety switch on this sander is equipped with an overload protection feature. To prevent an electrical
overload from damaging the motor, in the event of a spike in line voltage or amperage draw, the internal overload
protector will automatically be tripped, thereby cutting off power to the motor.
Note: The most common causes of such overloads are:
1. Overworking the motor by attempting to remove too much material in a single pass, thereby causing an increase in
power consumption and a spike in amperage draw.
2. An electrical extension cord that is too long or not the correct gauge of wire, which can also cause an increase in
amperage draw. If an electric extension cord must be used, follow the instructions and refer to the chart in the electri-
cal requirements section at the beginning of this manual.
3. Overworked circuit caused by operating on a circuit that is close to its amperage draw capacity. Make sure the cir-
cuit being used is capable of handling the amperage draw from this machine as well as any other electrical devices
operating on the same circuit. If you are unsure, consult a qualified electrician.
To reset the overload protection switch after it has been tripped proceed as follows:
TO AVOID UNEXPECTED OR UNINTENTIONAL START-UP BE CERTAIN THAT BOTH OF THE POWER SWITCHES HAVE BEEN SET TO
THE OFF POSITION BEFORE RE-SETTING THE OVERLOAD PROTECTION SWITCH.
1. Set both of the the power switches on the sander to
the off position and disconnect the machine from
the power source.
Note: If the sander is permanently connected to a circuit
(hard-wired), set the wall panel circuit breaker or main cir-
cuit interrupter to the off position.
2. Unscrew the 2 screws and remove the control
box front cover then press the red reset button .
3. Reinstall the control box cover.
4. Reconnect the sander to the power source.
5. You can now restart the sander by pushing on the
green button ON.
SWITCHES OFF
13