General International 15-030 M1, Руководство по установке и эксплуатации

Страница: 8 / 29

UNPACKING
BASIC FUNCTIONS
This 15" Open Type Wide Belt Sander has been designed for surface sanding of wooden cabinet doors, flat wood-
en panels and other natural wood products only. This sander is not intended and should not be used on any mate-
rials other than wood.
The oscillating feature allows for faster more efficient sanding. The cross grain sanding action caused by the oscil-
lation (horizontal travel) of the belt optimizes sanding efficiency and extends sanding belt life by using a larger area
of the belts’ surface. Another advantage of the oscillating action of the belt is to help dissipate surface heat buildup
– as heat build-up can cause premature belt wear.
Note: The minimum/maximum workpiece thickness capacity is 1/4” - 4”, and the minimum workpiece length
capacity is 5” long.
Note: As with any other drum or belt sander, depending on the final finish quality you require, some final hand sanding may
be required.
LIST OF CONTENTS
QTY
SANDER ..........................................................................1
REAR EXTENSION TABLE.................................................1
SIDE EXTENSION TABLE ..................................................1
SANDING BELT* .............................................................2
3 MM T-WRENCH* .........................................................1
19 MM COMBINATION WRENCH* ...............................1
10 - 12 MM OPEN END WRENCH* ...............................1
2 MM ALLEN KEY* .........................................................1
5 MM ALLEN KEY* .........................................................1
6 MM ALLEN KEY* .........................................................1
* The sanding belts and tools are stored inside the
sander cabinet to prevent damage in shipping. Open
the cabinet door and remove the sanding belts and
tools from the cabinet.
Carefully unpack and remove the sander and its components from the shipping crate and check for damaged or
missing items as per the list of contents below.
Note: Please report any damaged or missing items to your General International distributor immediately.
*
ADDITIONAL REQUIREMENTS FOR SET UP
• 11 mm Socket Wrench
• Phillips Screwdriver
• Gauge blocks (suggested)
• Shims or feeler gauge set (suggested)
8
*
*
*
*
*
*