General International 15-030 M1, Руководство по установке и эксплуатации

Страница: 17 / 29

1. Place a gauge block under the drive roller (with
sanding belt installed on), then place a 1 mm
thick shim or feeler gauge
on top of the gauge
block.
2. Adjust the height of the sanding head so that the
sanding belt is in full contact with the top of the
shim. Then tighten the locking handle
to secure
the sanding head in position and remove the
shim.
3. Place the gauge block under the left end of
the rear pressure roller . The top of the gauge
block should be in full contact with the pressure
roller
4. If needed, adjust the height of the pressure roller
with the supplied 2 mm allen key by turning the
adjustment screw
.
CLOSE-UP
5. Repeat step 3 and, if needed step 4 for the right end of the rear pressure roller then for both ends of the front
pressure roller.
Verify and, if needed, adjust the height of the pressure rollers as follows:
LOWER
RAISE
17
For the following adjustments, we recommend that
you use a 1 mm shim and feeler gauge
and a home
made gauge block made of hardwood.
The gauge block can be made by following the di-
mensions shown in
.