General Dynamics CG-1220, Руководство по эксплуатации и обслуживанию

Страница: 72 / 134

Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, June, 2012)
11
Continued on the next page
MAIN MENU TYPE PARENT MENU
CONFIGS…(CONTINUED) Sub Menu MAIN MENU
BANDS (“CONVERSION BANDS”)… Sub Menu CONFIGS
(ONLY in units with BDC)
BAND-1… Sub Menu BANDS
BDC-GAIN Data Editor BAND-1
OSC-FREQ Data Editor BAND-1
LOW-FREQ Data Editor BAND-1
HIGH-FREQ Data Editor BAND-1
LBAND-DEFAULTS Executable BAND-1
BAND-2, 3, 4… Sub Menu BANDS
BDC-GAIN Data Editor BAND-2
OSC-FREQ Data Editor BAND-2
LOW-FREQ Data Editor BAND-2
HIGH-FREQ Data Editor BAND-2
BEACONS (“BEACON SETUP”)… Sub-Menu CONFIGS
(ONLY in Non-Monopulse units)
STORE-BEACONS… Sub-Menu BEACONS
STORE-BEACON1 Executable STORE-BEACONS
STORE-BEACON2 Executable STORE-BEACONS
STORE-BEACON3 Executable STORE-BEACONS
STORE-BEACON4 Executable STORE-BEACONS
RESTORE-BEACONS… Sub-Menu BEACONS
RESTORE-BEACON1 Executable RESTORE-BEACONS
RESTORE-BEACON2 Executable RESTORE-BEACONS
RESTORE-BEACON3 Executable RESTORE-BEACONS
RESTORE-BEACON4 Executable RESTORE-BEACONS
MONOPULSE (“MONOPULSE”)… Sub-Menu CONFIGS
(ONLY in Monopulse units)
MUTE Data Editor MONOPULSE
MUTE-FAULT Data Editor MONOPULSE
RATE Data Editor MONOPULSE
MODE Data Editor MONOPULSE
START Executable MONOPULSE
MEMORY (“SYSTEM MEMORY”)… Sub Menu CONFIGS
CALIBRATION (“FACTORY CALIBRATION”) Sub Menu SYSTEM MEMORY
SAMPLING (“SAMPLING FREQUENCY”) Data Editor CALIBRATION
NCO (“NCO OFFSET”) Data Editor CALIBRATION
CALIBRATION (“POWER LEVEL CALIB”) Data Editor CALIBRATION
IF-OVERRIDE (“MANUAL IF OVERRIDE”)… Sub Menu CALIBRATION
F1-OVERRIDE (“FREQ #1 IF OVERRIDE”) Data Editor IF-OVERRIDE
F2-OVERRIDE (“FREQ #2 IF OVERRIDE”) Data Editor IF-OVERRIDE
F3-OVERRIDE (“FREQ #3 IF OVERRIDE”) Data Editor IF-OVERRIDE
F4-OVERRIDE (“FREQ #4 IF OVERRIDE”) Data Editor IF-OVERRIDE
OPTIONS (“HARDWARE OPTIONS”) Sub Menu SYSTEM MEMORY
POL-INPUTS Data Editor OPTIONS
DATE&TIME (“SET DATE AND TIME”)… Sub Menu MEMORY
SET-DATE Data Editor DATE&TIME
SET-TIME Data Editor DATE&TIME
RESTORE-TO-ROM-DEFAULTS Data Editor MEMORY
CLEAR-FAULTS (“FORCE CLEAR FAULTS”) Executable MEMORY
UI-OPTIONS (“INTERFACE OPTIONS”)… Sub-Menu CONFIGS
CONTRAST (“LCD CONTRAST”) Data Editor UI-OPTIONS
LOW-SIGNAL-LEVEL Data Editor UI-OPTIONS
LOW-SIGNAL-ALARM Data Editor UI-OPTIONS
TEMP-LIMIT (“HIGH TEMP LIMIT”) Data Editor UI-OPTIONS
ACKNOWLEDGE-FAULTS Executable MAIN MENU
Continued on the next page