![Generac Power Systems RXSW400A3CUL Скачать руководство пользователя страница 13](http://html1.mh-extra.com/html/generac-power-systems/rxsw400a3cul/rxsw400a3cul_owners-manual_2209822013.webp)
Installation
Automatic Transfer Switch Owner’s Manual
9
Section 3: Installation
Introduction to Installation
This equipment has been wired and tested at the factory.
Installing the switch includes the following procedures:
•
Mounting the enclosure.
•
Connecting power source and load leads.
•
Connecting the generator start and sensing circuit.
•
Connecting any auxiliary contact (if needed).
•
Testing functions.
Mounting
Mounting dimensions for the transfer switch enclosure
are in this manual. Enclosures are typically wall-
mounted. See
.
This transfer switch is mounted in a UL/CUL type 3R
enclosure. It can be mounted outside or inside and
should be based on the layout of installation, conve-
nience, and proximity to the utility supply and load center.
Install the transfer switch as close as possible to the elec-
trical loads that are to be connected to it. Mount the
switch vertically to a rigid supporting structure. To pre-
vent switch distortion, level all mounting points. If neces-
sary, use washers behind mounting holes to level the
unit.
Open Enclosure
See
. First, remove outer cover (A):
1.
Remove two thumb screws (B).
2.
Slide slot (C) over retention tab.
3.
Lower outer cover until clear of top flange (D), and
pull away from enclosure.
Then,
remove inner panel (E):
4.
Loosen nut (F) until it clears t-slot (H) in inner
panel.
5.
Grasp inner panel at two cutouts (G—left and
right). Tilt inner panel as shown, passing nut
through t-slot.
6.
Lower inner panel until tabs (J) clear upper panel,
and pull away from enclosure.
Lastly, remove service entrance panel (L):
7.
Remove screw (K). Lower inner utility service
entrance access panel (L) until clear of two reten-
tion slots in top flange, and pull away from enclo-
sure.
Figure 3-1. Open Enclosure
(000119)
Equipment malfunction. Installing a dirty or damaged
transfer switch will cause equipment malfunction and
will result in death or serious injury.
DANGER
008982
B
A
C
E
F
D
J
G
H
K
L
B
Содержание RXSW400A3CUL
