Operation
Owner’s Manual for Australian 50 Hz Air-Cooled Generators
15
LED Indicator Lights
See
. Three LEDs are visible behind a translu-
cent lens on the generator set side panel. These LEDs
indicate the operating status of the generator set.
Figure 3-5. LED Indicator Lights
•
Green LED “Ready” light (A) illuminates when
mains power is present and control panel button is
in AUTO. The LED flashes when the automatic
transfer switch converts to generator set power
during a mains power outage.
•
Red LED “Alarm” light (B) illuminates when gener-
ator is OFF or a fault is detected. Contact an IASD.
•
Yellow LED “Non-Critical Alert” light (C) illuminates
when scheduled maintenance is required.
NOTE:
Yellow LED may be illuminated at same time as
either the red or green LED.
Control Panel Interface
See
. The control panel interface (A) is located
under lid of the enclosure. Verify both left and right side
locks are unlocked before attempting to lift lid of enclo-
sure. Open lid as directed in
The 7.5A fuse is located beneath rubber cover (B) to the
right of the control panel.
Verify both left and right side locks are securely out of the
way before closing lid.
Figure 3-6. Generator Control Panel
All appropriate panels must be in place during any opera-
tion of generator set. This includes operation by a servic-
ing technician while conducting troubleshooting pro-
cedures.
Using the Control Panel Interface
NOTE:
Damage caused by mis-wiring of the
interconnect wires is not warrantable.
Interface Menu Displays
LCD Panel
001791
A
C
B
001798
A
B
Button
Description of Operation
AUTO
Activates fully automatic system operation. It
allows unit to automatically start and exercise
generator set according to exercise timer (see
Green LED flashes when automatic transfer
switch converts to generator set power during a
mains power outage.
OFF
Shuts down engine and prevents automatic
operation of unit.
MANUAL
Cranks and starts generator set. Transfer to
standby power will not occur unless there is a
mains power failure.
Blue LED flashes when automatic transfer
switch converts to generator set power during a
mains power outage.
Feature Description
HOME
page
Default page that is displayed if no buttons are
pressed for 60 seconds. Normally shows current
status message and current date and time. High-
est priority active alarm/warning is automatically
posted on page, as well as flashing the backlight
when such a condition is detected. In the case of
multiple alarms/warnings, only first message will
be displayed. Press OFF button and then press
ENTER button to clear an alarm or warning.
When “Hours of Protection” is displayed, this rep-
resents total time unit has been monitoring mains
power supply and ready to provide backup power
if needed.
Display
Backlight
Normally off. Backlight will automatically light and
remain on for 30 seconds if user presses any but-
ton.
MAIN
MENU
page
Allows user to navigate to all other pages or sub-
menus by using arrow keys and ENTER button.
Page can be accessed at any time with several
presses of dedicated ESCAPE button. Each
press of ESCAPE button takes user to previous
menu until MAIN MENU displays. This page con-
tains information for - History; Status; Edit;
Debug.
