Gems LDS4, Руководство по эксплуатации, Страница: 31 / 71

25 The Setup Editor
© 2009 General Engine Management Systems Ltd.
4.22.7 Case Input Editor
This editor is shown when setting the inputs to an output using a Case sensor.
Set the number of conditions in the condition count box then fill in the grid with the conditional
channels and the output they are to produce.
4.23 Predefined Outputs
There are a number of outputs and sensors automatically added to the display setup. These
should not be deleted as they can be critical to the display operation. Note that outputs predefined
by the co-driver functionality are discussed in
Special Co-driver Outputs .
4.23.1 Screen Select
The Screen Selector output is the analogue screen select. It uses a function table called
ScreenSel ssr which is pre-calibrated by GEMS for the recommended page select. If you have
used a different page select switch, this function table may need to be recalibrated.
4.23.2 Analogue Outputs
The LDS4 has 7 analogue inputs named A1 Raw, A2 Raw etc. The inputs have 12 bit resolution
with a range of 0 to 4095.
4.23.3 Speed Outputs
LDS4 has 4 speed inputs and these are shown in the setup as outputs called Speed 1 Raw,
Speed 2 Raw etc. The raw speed outputs are scaled in Hz.
4.23.4 Lap Time Outputs
LDS4 can perform lap timing when connected to a suitable beacon. The following lap time
outputs are available:
·
Current Lap Num - The current lap number. This is zero until the first beacon has been
passed then increments by 1 each time a beacon is passed.
· Current Lap Time - The elapsed time of the current lap. When a beacon is passed, the lap
time will freeze for 3 seconds to show the time of the lap just completed before resuming to
show the new current lap time.
·
Last Lap Num - The number of the last lap just completed.
· Last Lap Time - The lap time of the lap just completed.