PAGE 25
PAGE 26
22.0 - DIODE INSTALLATION
Activate one of the turn indicators, turn ignition key OFF and arm the alarm.
If the instrument panel lights up when the turn indicators are activated, a
diode needs to be installed (follow diagram below).
!
How to tell if you need to install a diode:
!
Vehicle wiring harness
After
Turn indicator
relay
WHITE wire
Cut
Diode installed
in-line
Vehicle original
wire
Live feed to
turn indicators
BLACK wire
Before
CAUTION
23.0 - LEARNING NEW DEVICES
The alarm system is supplied with 1 active remote control and 1 TAG that must
be activated.
To pair the TAG and learn new devices, follow one of the 2 procedures:
Alarm memory will only store 8 devices.
Saving an extra device will automatically delete the first one.
23.1 - BY GROUNDING THE BROWN/GREEN WIRE:
!
!
Disarm the alarm system via remote control.
Lift the seat or open the topcase (if fitted with a contact switch) otherwise
ground the BROWN/GREEN wire.
!
Ground the White-Violet wire (with or without a Yellow end connector).
!
!
!
!
!
Turn ignition key in ON.
Press the TAG button or one of the buttons on the remote control to be
learned.
A flash of the turn indicators and a Beep will confirm the new remote has
been learned.
If other devices need to be learned,
then press
the button on the device to be learned.
To exit the learn procedure, turn ignition key OFF. A Bop and a single flash
of the turn indicators will confirm the end of the procedure.
Close the seat/topcase or remove the BROWN/GREEN wire from
ground.
!
!
!
Disconnect the White-Violet wire.
repeat the above procedure
2 flashes of the turn indicators and 2 confirmation tones (1 Bop and 1 Beep)
will acknowledge the system is in learn mode.
23.2 - WITHOUT GROUNDING THE BROWN/GREEN WIRE:
!
!
!
Disarm the alarm system via remote control.
Turn ignition key in ON.
.
If other devices need to be learned, wait 2 sec. and then press the button on
the device to be learned.
To exit the learn procedure, turn ignition key OFF.
!
!
The status LED will light up for 1 sec.; while the LED is ON, simultaneously
press both buttons on the active remote control.
2 flashes of the turn indicators and 2 confirmation tones (1Bop and 1 Beep)
will acknowledge the system is in learn mode.
!
!
!
Press the TAG button or one of the buttons on the remote control to be
learned
A Bop and a single flash of the turn indicators will confirm the end of the
procedure.
