ATTENTION
!
CAUTION
Non compliance to this instruction could result in serious damage to the
vehicle and to the alarm system.
Non compliance to this instruction may cause damage or operational
failures to the alarm system.
USER MANUAL
1.0 - INTRODUCTORY NOTE
Dear customer,
This self-powered alarm system,
designed and manufactured for 2-
wheeled vehicles, is supplied with 1 transponder (RFID TAG) and 1 remote control.
specifically
2.0 - ALARM SYSTEM CONTROL DEVICES
The remote control and the transponder are used to operate the alarm system.
S
PIN code can be entered to
emergency override the system.
Override PIN code is entered by means of the vehicle ignition key (see chapter 7.0).
hould these devices be lost or inoperative, a
Button 1
LED
indicator
Button 2
The following signal words are included in the present manual to emphasize
important instructions and to alert the user/installer to potential hazards:
PAGE 3
PAGE 4
2.2 - REMOTE CONTROL
The remote control has a low charge battery indicator that gives early warning
to avoid malfunctioning. When the batteries are low, the LED will blink when
one of the buttons is pressed. Replace the batteries: weak batteries will
prevent the remote control from properly operating the alarm system (see
par.10.0).
The remote control has 2 buttons that activate several functions based on the
alarm configuration:
Button 1
(textured):
Button 2
(smooth):
• Alarm system arming/disarming.
• Anti-hijack activation.
• Hazard flashers activation.
• Anti-hijack activation.
• Panic alarm activation/deactivation.
• Siren silencing during an alarm.
• Siren exclusion when arming.
The transponder is not active, it must be initially paired with the
alarm system.
The alarm is factory programmed but certain features can be user-customized
and tilt/shock sensor sensitivity adjusted (see par. 26.0).
Please read the present manual carefully to familiarize yourself fully with the
alarm features and operating procedures and do keep it handy for future
reference.
2.1 - TRANSPONDER
The transponder is not factory learned, it must be initially
paired with the alarm system as indicated in par. 23.0.
The transponder can only be used to disarm the alarm system.
To activate the transponder
; the LED will turn ON steady when the TAG is activated. Release
the button. The LED will flash each time the TAG transmits.
If no movement is sensed for 10 min. the TAG automatically goes into stand-by
mode to save battery life; to “wake it up” for another transmission cycle, move it
or press the button.
To turn the TAG OFF, press the button and keep it pressed for at least 10 sec.
The LED will turn ON steady and, after 10 sec., it will quick flash twice to
confirm powering OFF.
simply press the button and keep it pressed for at
least 4 sec.
Pressing the TAG button sends radio signals to the alarm system.
