CAUTION
25.0 - PROGRAMMING EXAMPLE
Here below is a step-by-step example showing how to program the system
with the tilt sensor and self-rearming disabled.
.
Keep in mind that, at every button press, the system automatically scrolls to the
next feature.
With the system disarmed, lift the seat/topcase (if protected by a contact
switch) otherwise ground the BROWN/GREEN wire.
Turn ignition key in ON; the LED will light up for approx. 1 sec.
While the LED is ON, simultaneously press both remote control buttons; 2
Beeps will confirm the system is in programming mode and the LED will
light up steady.
Press remote control button 1; a Beep will confirm acoustic signals are
enabled.
; a Beep will confirm that the panic alarm is
enabled.
Press button 1; a Beep will confirm that passive arming is enabled.
Press button 1; a Beep will confirm that the anti-hijack feature is enabled.
Press button 1; a Beep will confirm that the pre-alarm feature is enabled.
Press button 2; a Bop will confirm that
is disabled.
When the last feature has been configured, the system automatically exits
the programming procedure; 2 Bops and 1 Beep will confirm the end of the
procedure. The status LED will power OFF.
Turn ignition key OFF, close the seat/topcase or remove the BROWN-
GREEN wire from ground.
!
!
!
!
!
self-rearming
!
!
!
!
!
!
Press remote control button 1
Press button 2; a Bop will confirm that the
is disabled.
tilt sensor
You can exit the programming procedure at any time by turning ignition
key OFF.
Programmed features will automatically be saved while the others will
remain unvaried.
PAGE 29
26.0 - TILT SENSOR ADJUSTMENT
The alarm system has a built-in triaxial tilt/shock sensor with 4 levels of
sensitivity adjustment. T e shock sensor is factory preset to be at minimum
sensitivity.
To change the sensitivity level proceed as follows:
Disarm the alarm system via
Lift the seat/topcase (if protected by a contact switch) otherwise ground the
BROWN/GREEN wire.
.
!
!
!
h
remote control.
Turn ignition key ON; the status LED will turn ON for approx. 1 sec
!
While the LED is ON, press remote control button 2 and press it again within 2 sec.
CAUTION
The procedure will be voided if more than 2 seconds go by between the
first button press and the second.
!
!
Two LED flashes and two Beeps will confirm the system is in adjustment
mode.
Sensor is at the lowest sensitivity level.
!
!
!
!
Press remote control button 2 to increase sensitivity by one (press 3 times
to set at maximum level); a LED flash and a Beep will confirm each change
of setting.
When the sensor is adjusted, turn ignition key OFF.
If adjusted at the highest level (3 button presses), the system automatically
exits the procedure.
In both cases, a LED flash and Beep will confirm the end of the procedure.
!
.
Turn ignition key OFF. Close the topcase/seat or remove the
BROWN/GREEN wire from ground
CAUTION
Every time you enter the programming procedure, sensitivity is restored to
the factory default setting.
PAGE 30
