V
02/16
OptiMove CR08
Operation
•
23
Operation
Operating the axis control unit
Up to 255 programs can be entered and/or recalled with the OptiMove
CR08 Axis control unit. Each program contains data about the speeds
and the positions of the axis movements.
Switch on/off the axis control unit
1. Push
the button
The LED above the key illuminates
By first switch on of the equipment, the preselected factory settings are
displayed:
xxx
on the display
A1
= value for position
xxx
on the display
A2
= value for speed
xxx
on the display
A3
= program number
2. Press
the key
The device is switched off
By switching off the equipment (also when the equipment is disconnected
from the mains), the actual settings are retained.
Travel to reference point
In order that the OptiMove CR08 axes control unit can enter the position
of the axis as accurately as possible during operation, the triggered axis
must first travel to the reference point each time it is switching on. The
prerequisite for this is that the reference point is already set correctly (see
also the corresponding instructions in the respective axis operating
manual).
The axis must also be referenced again after each axis-specific
error (H01, H02, H03, H04).
– If the axis is referenced, it cannot be referenced a second time
unless the above conditions are given.
1. Press
the key
