V
02/16
22
•
Start-up
OptiMove CR08
System parameter P1 – setting the upper stroke
limit
If the axis control unit operates with a Gema axis, all system parameters
are already set to the values for this axis. The only system parameter to
be set is the upper stroke limit.
The maximum stroke height (max. travel) is limited by the upper stroke
limit. The maximum stroke height is limited by the corresponding height of
the used reciprocator or by the maximum height of the gun slots in the
booth. The upper stroke limit of the OptiMove CR08 Axis control unit is
always set at 0.3 meters by the factory.
In order to set the upper stroke limit (system parameter 1), proceed as
follows:
1.
To enter the system parameter mode, press and hold the
key for
5 seconds.
The LEDs
L1-L3
illuminate
2.
Select the parameter
P1
on the display
A1
by using the
keys
3.
Set the upper stroke limit value on the display
A2
using the
keys
ATTENTION
An incorrect (too high) set stroke limit will lead to damage to the
axis and/or the booth!
►
Always pay attention to the gun positions and the maximum
height of the gun slots in the booth!
4. Press
the key, in order to exit the system parameter mode
