GEISMAR MPR-M, Инструкция по эксплуатации и техническому обслуживанию

Страница: 43 / 132

Chap. 6 — page 33
L.GEISMAR Company – Prohibited Reproduction©
HYDRAULIC RAIL THREADER H90461 / NO 10055
TYPE MPR – M
Chapter 6 – Servicing
6 – 1 General maintenance instructions
Before starting operations, the parts which will be in contact with the Rail
Threader must be cleaned carefully as well as the neighbouring zones, to prevent
impurities from getting into the machine's mechanisms.
6 – 1 – 1 Rules to be followed
– Draw up an inspection schedule and record all maintenance operations.
– Replace any suspicious or worn parts.
– Never neutralise the prevention or limiting equipment.
– Never use the machine as an "earth" for welding operations.
H
YDRAULIC TANK
Check the oil level in the hydraulic tank regularly, with cylinder rods retracted
(this level must be at three-quarters on the tank level indicator (fig. 6.1.1.a). Top up if
necessary.
Fig : 31
Drain the tank after 1000 hours of operation (max. 1 year).
H
YDRAULIC HOSES
Check the water-tightness and tightening of couplings. Replace hoses as soon
as a bruise or tear is reported. You must keep them in good condition, because
operational safety depends on this equipment. Keep all the joints in good condition,
coating them with lubricant regularly to protect them against rust.
I
NTERNAL
C
OMBUSTION ENGINE
For basic engine verifications and servicing the motor, use the "preventive
maintenance timetable" below. For further details on engine servicing, see the
instructions provided by the manufacturer.
Minimum level