GEISMAR MPR-M, Инструкция по эксплуатации и техническому обслуживанию

Страница: 36 / 132

H90461 / NO 10055 HYDRAULIC RAIL THREADER
TYPE MPR – M
Chap. 5 — page 26
L.GEISMAR Company – Prohibited Reproduction©
5 – 3 Putting the Rail Threader onto the track
Set the Rail Threader onto the site track using a lifting device or the optional
equipment provided for the purpose (see appendix Optional equipment ) Switch the
battery On (see § 4 fig. 4.7.3.b). Start the motor (in cold weather, use the manual
preheating, see Hatz service instructions) The equipment is ready to work.
5 – 4 Position on the site
5 – 4 – 1 Track replacement site
The Rail Threader follows the team laying ties using hydraulic gantries and
precedes the team which fastens the rails.
The rails to be laid act as a track for the hydraulic gantries used to lay ties as well
as the Rail Threader. They are laid with wide spacing (3330 mm). The Rail Threader is
used to pick up these rails and lay them on the ties at the rated gauge (fig. 21)
Fig : 21
During this operation is is PROHIBITED for anyone to move around in front
of and beside the Rail Threader. Any operation to be carried out in front of
or beside the machine must take place with the motor off and the parking
brake locked.