8
Gerhard Geiger GmbH & Co. KG | 100W2580
0322
V000
en
EN
EN
12. Manual programming of the end positions
I
The distance between the upper and lower end stops must be about
7 cm which corresponds to 1/4 tube rotation at least. If the distance is
not maintained the drive deletes the end positions that have already
been stored and starts again with the programming.
Programming the end positions
1.
To activate the programming mode, press the PROG key or the UP and DOWN keys
simultaneously until the motor confirms (1 x „clac-clac“). The learning mode is indicated with
each move command by a short interruption of the screen movement (start-stop-start).
2.
Press and hold the UP or DOWN key to move the screen to the desired end stop until the
desired position is reached.
3.
The position is saved by pressing the PROG key for at least 1 sec. The drive signals that
the first end position has been saved (2 x „clac-clac“)
.
4.
Press and hold the UP or DOWN key to move the screen in the opposite direction until the
desired position is reached.
5.
The position is saved by pressing the PROG key for at least 1 second. The drive signals that
the second end position has been saved (3 x „clac-clac“)
.
6.
The learning process is then completed and the motor switches to normal operation.
13. Semi-automatic programming of the end positions
I
The distance between the upper and lower end stops must be about
7 cm which corresponds to 1/4 tube rotation at least. If the distance is
not maintained the drive deletes the end positions that have already
been stored and starts again with the programming.
Programming the end positions
1.
To activate the programming mode, press the PROG key or the UP and DOWN keys
simultaneously until the motor confirms (1 x „clac-clac“). The learning mode is indicated with
each move command by a short interruption of the screen movement (start-stop-start).
2.
Keep the UP or DOWN key pressed to move the screen to the desired end position until the
motor reaches the stop and switches off (torque shutoff).
3.
Press and hold the UP or DOWN key to move the screen in the opposite direction until the
desired position is reached.
4.
The position is saved by pressing the PROG key for at least 1 second. The drive signals that
the second end position has been saved (3 x „clac-clac“)
.
5.
The learning process is then completed and the motor switches to normal operation.
14. Exit the programming modes
The learning process can be cancelled completely at any time by pressing the PROG key for 20
to 30 sec. The drive signals the termination by 4x UP/DOWN movements.
The drive returns to the delivery state.
15. Change/delete the end position
In order to change or delete the end positions, a new programming must be started (see
«Setting of the end stops»).