50960066/AP0813
56
PRINTED IN U.S.A.
3.
Clean any large debris that may have collected on
the top side of the condenser.
4.
Clean the condenser use a jet of compressed air
aimed in the same direction as the air flow.
NOTE:
To aid in the cleaning process, carry out
this operation with the condenser fans running.
5.
Re-install the top cover.
CLEAN/CHANGE CAB VENTILATION
FILTER
NOTE:
Clean or change the filter more often if
there is a noticeable decrease in air flow from the
air vents.
1.
Remove the four screws (1) from the filter pro-
tective cover located on the lower portion of the
dash in front of the brake pedal.
2.
Remove the filter from the cover.
3.
Clean the filter with a jet of compressed air.
4.
Check the condition of the filter and replace it if
necessary.
5.
Install the filter in the protective cover, then re-
install the protective cover.
Perform all other service requirements up to this point,
as well as the following:
CHECKING AND CHANGING
HYDRAULIC RETURN FILTER
ELEMENT
This spin-on type hydraulic filter element is located
under the engine cover behind the radiator. Open the
engine cover to access the hydraulic filter. Initial
replacement is after the first 100 hours. The hydraulic
filter element should be replaced every 500 hours or
anytime the indicator on the multi-function display
stays lit. Replace the filter using the following the pro-
cedure:
1. Turn off the engine.
2. Place a suitable container under the filter to catch
any spilled oil.
3. Spin off the old hydraulic filter element.
3. Wipe the gasket sealing surface of the filter head
with a clean cloth.
4. Apply a thin coat of clean oil to the new filter gas-
ket.
5. Spin on the new filter element and hand tighten.
6. Run the engine at full throttle and check for leaks
at the filter sealing area.
Perform all other service requirements up to this point,
as well as the following:
CHECKING AND CHANGING AIR FIL-
TER ELEMENTS
IMPORTANT:
Failure to follow proper filter servic-
ing instructions could result in catastrophic engine
damage.
The air cleaner assembly consists of an outer (primary)
filter element and an inner (secondary) filter element.
Service Every 1000 Hours or Yearly
Hydraulic
Filter
Service Every 500 Hours or Half Year
WARNING
Before servicing the hydraulic filter, lower the
boom to the ground.
1
Содержание RS5-19
