Gehl RS5-19, Руководство оператора

Страница: 53 / 82

PRINTED IN U.S.A.
51
50960066/AP0813
CHECKING WHEEL NUT TORQUE
On new machines, or any time a wheel has been
removed, re-torque until 450 ft.-lbs. (610 Nm) is main-
tained.
CHECKING INSTRUMENTS OPERA-
TION
Allow the engine to warm up for about five minutes
before beginning operation. Indicator lamps should be
OFF and gauges in the multi-function display should
register normal readings.
CHECKING GENERAL MACHINE
OPERATION AND CONDITION
Are any decals missing or damaged? Are all guards,
shields and covers in place? Do all controls function
smoothly and properly? Are there any abnormal vibra-
tions or noises? Are any hose or fitting connections
leaking? Is the engine exhaust color normal?
LUBRICATING GREASE POINTS
Refer to the Lubrication chapter of this manual for
weekly grease fitting locations and other related
details.
DRAINING FUEL FILTER/WATER SEP-
ARATOR
Drain the fuel filter/water seperator anytime water or
other contaminants are present.
The semi-transparent seperator cup contains a red float
ring. The float ring will rise to the surface of the water
to show how much water needs to be drained.
1. Place a suitable container under the water separa-
tor to catch drained water.
2. Close the fuel shutoff valve located on the fuel fil-
ter head by rotating it 1/4 turn clock-wise to the
horizontal position.
3. Loosen the drain screw at the bottom of the fuel
filter/water seperator to drain the acumulated
water.
4. Tighten the drain screw and open the fuel shutoff
valve.
5. Prime the fuel system by turning the ignition key
ON for 10 -15 seconds.
The following initial oil and filter changes should be
made on a new machine:
1. Change the engine oil and filter after the first 50
hours of use.
2. Change the hydraulic return filter element after the
first 100 hours of use.
Thereafter these changes should be made at the regular
maintenance schedule listed below. Refer to those
schedules for the necessary procedures.
Engine Oil and Filter (250 Hours)
Hydraulic Return Filter Element (500 Hours)
Perform all other service requirements up to this point,
as well as the following:
CHECKING AXLE OIL LEVELS
Differential
NOTE: The Telescopic Handler should be on a
level surface for this procedure.
Remove the oil check/fill plug. See illustration. Oil
should flow from the hole. If low, add oil until it flows
from the hole. Replace the plug, wait 10 to 15 minutes
and repeat the fill procedure. Continue this process
until the differential is full. Refer to the Lubrication
Service Every 250 Hours or Quarterly
New Machine Service
IMPORTANT
Water in the fuel system can cause severe
engine damage. Drain water from the fuel fil-
ter/water separator anytime water is present.
Fuel Drain
Screw
Fuel Shutoff
Valve
Service Every 50 Hours or Weekly