GEHEIT PN 1, Руководство по эксплуатации

Страница: 9 / 24

7
●
Always turn off the compressed air supplied by the blower before the paint container of the
ABAC Spray Gun PN 1 / PN 1A is refilled with paint.
●
Repairs and maintenance works must only be carried out by authorized specialists or
by us (ABAC). Addresses of authorized firms can be obtained from us or from your
dealer upon request.
●
Take care not to spray in the direction of the blower.
●
Dispose of cleaning and spraying material wastes according to the instructions given by the
relevant lacquer, paint and solvent manufacturers.
5 Transportation and storage
The ABAC Spray Gun PN 1 / PN 1A is supplied in a cardboard box. To avoid damage during
transportation and storage, we recommend to use this original packaging. Store your equipment
in a dry ventilated room.
Ambient temperature range for equipment storage is from 0
°
С
to +45
°
С
, relative humidity must
not exceed 80%.
6 Start-Up and Operation
6.1 Connecting the Spray Gun
●
Insert the air hose of the ABAC low-pressure blower into the insulated handle of the spray
gun (see Fig.1).
6.2 Paint Preparation
●
To ensure a satisfactory finish and problem-free working, particular attention must be paid to
preparation of paints and / or lacquers.
Before you begin spraying, thin paints with the solvent specified by the supplier (if
necessary). Add enough thinner so that after sufficient stirring the paint easily runs off the
stirrer. To avoid uncertainly, we recommend the use of the dipper for viscosity check,
whereby the time taken for the paint to run out shows whether the paint is still too thick and
requires further thinning. As a general rule, the run out time is 18 to 30 DIN seconds for
paints and lacquers, and 25 to 50 DIN seconds for special-effect lacquers and coating fillers
(see section 13 Annex). These values were determined at a temperature of 20
°
C / 70
°
F.
Lacquer and paint manufacturers usually specify the most favorable spraying consistency for
their products.