GEHEIT PN 1, Руководство по эксплуатации

Страница: 12 / 24

10
6.6 Filling the Paint
The paint container should be filled no higher than 2 cm below the brim. Close the lid securely.
If the lid is not properly closed the gun will not work correctly.
Attention! Do not lay down the filled gun but place it on a stand
or the spray gun holder, so that paint cannot flow into the
pressure hose through the small opening in the lid of the paint
container. We highly recommend always use the spray gun
holder for resting the gun on.
●
The paint must first be thinned to spraying consistency in order to obtain the optimal spray
gun setting. Before starting the actual spraying work it is advisable to spray a specimen (e.g.
on cardboard or wood). Start spraying only after the result of specimen spraying is
satisfactory.
●
Ensure that the adjoining areas of the object to be sprayed have been carefully covered.
7 After Paint Spraying has Finished
After you have finished spraying, turn off the ABAC low-pressure blower. Then disconnect the
air hose from the insulating handle of the ABAC Spray Gun PN 1 / PN 1A. Clean the spray gun
as described in section 8.1.
8 Care, Maintenance and Repair
Always disconnect the air hose of the ABAC low-pressure
blower from the spray gun prior to all care, maintenance and
repair work.
Repairs must only be performed by authorized specialist firms
or by us. A list of authorized firms can be obtained from us or
your dealer.
A special after-sales service for the ABAC Spray Gun PN 1 / PN 1A is not necessary. However,
the packing seal and the lid seal must be replaced when they are worn out (see section 9).
8.1 Cleaning the Spray Gun
The spray gun should be cleaned immediately after the spraying work has been completed. The
cleaning procedure is as follows:
1) Pour out any remaining paint.
2) Rinse out the paint container thoroughly with a suitable solvent. During rinsing, operate
the trigger several times to clean the paint channels and nozzle.