Fig.17
2.
Before fitting, wet the V-ring on the side not in contact with product (rear side).
Pay attention that water does not drip into the V-ring groove on the valve disk.
3.
Air out the valve upon connection (22).
4.
Put in the V-ring. Make sure the installation position of the V-ring is correct
(see illustration).
Fig.18
5.
Use the insertion tool to press in the V-ring – evenly press in at several
opposite points along the circumference.
Fig.19
6.
Insert the V-ring evenly.
7.
Replace all the other seals identified in the spare parts lists.
®
Done
Hint!
Used seals must not be used again, since the proper function of the
seal can then no longer be ensured.
10.6.3 Lubricating seals and threads
Maintenance
Maintenance
430BAL008326EN_3
07.02.2022
47
