GEA T.VIS P-15, Инструкция по эксплуатации

Страница: 34 / 66

3.
Tighten the clamps (15) and screws (39) to a torque of 1 Nm (0.7 lbft).
4. Align the pneumatic and electrical connections in accordance with the valve
block configuration.
5.
Perform commissioning, see Chapter 6, Page 25 and Chapter 7, Page 38.
®
Done.
6.6.4 Mounting to ECOVENT Valves N_ECO and W_ECO
Requirement:
•
Pay attention not to kink the air hoses when mounting the control top.
Carry out the following steps:
1. Complete the T.VIS mounting base (198) with O-rings (29, 101) and a plain
bearing (202).
Fig.20
2. Screw the mounting base (198) into the actuator (A.4) and tighten using a
face spanner.
3. Screw the switch bar (1) with ring (99) into the piston rod (A4.1) and tighten
by applying an a/f 13 open end spanner at (1.1); torque 2 Nm (1.4 lbft).
4.
Fit the control top (B) over the switch bar (1) and on the actuator.
5. Tighten the clamps (15) and screws (39) to a torque of 1 Nm (0.7 lbft).
6.
Align the pneumatic and electrical connections in accordance with the valve
block configuration.
7. Due to the internal air guiding of the control top (B), the connection A 4.2 on
the actuator and air connection Y1 (23) on the steering top are closed.
8. Perform commissioning, see Chapter 6, Page 25 and Chapter 7, Page 38.
®
Done.
6.6.5 Mounting to VESTA Valve H_A/M
Requirement:
•
Pay attention not to kink the air hoses when mounting the control top.
Assembly and installation
Mounting the Control Top to Different Valves
430BAL010747EN_3
34 24.07.2020