GEA T.VIS M-15, Руководство по эксплуатации

Страница: 74 / 130

Mounting the Control Top to Different Valves
Mounting to ECOVENT Valves N_ECO and W_ECO
74
Operating Instructions · Control Top T.VIS
®
M-15
Edition 2017-10-16
5.
Close air connection Y1 with a plug (23), as the air is guided inside the T.VIS M-15
control top.
6.
Carry out commissioning, see chapter “Setting into Operation“ (page 50).

Done
Mounting to ECOVENT Valves N_ECO and W_ECO
Requirement:

Pay attention not to kink the air hoses when mounting the control top.
IMPORTANT NOTE
The permanent magnet on the switch bar is fragile.
Damage to the permanent magnet.
 Protect the permanent magnet against impact stress.
IMPORTANT NOTE
Magnetic fields resulting from the permanent magnet on the switch bar.
Magnetic fields can delete data carriers and affect or destroy electronic or mechanical
components.
 Protect the components against the magnetic fields from the switch bar.
Carry out the following steps:
1.
Complete the T.VIS mounting base (198) with O-rings (29, 101) and a plain bearing
(202).
2.
Screw the mounting base (198) into the actuator (A4) and tighten using a face
spanner.
3.
Screw the T.VIS/Eco-E switch bar (1) with into the piston rod (A4.1) and tighten by
applying an a/f 13 open end spanner at (1.2), tightening torque 2 Nm.