GE ZBD4800XBB, Руководство по установке

Страница: 11 / 24

Models ZBD4600X and ZBD4700X will
accept 1/4" thick custom door and
access panels.
• Cut 1/4" thick door panel: 23-1/4"
wide, 22-11/16" high.
• Cut 1/4" thick access panel: 23-1/4"
wide, 1-1/2" high.
Cut edges of the panels will be con-
cealed by the trim.
Cut a notch in the top corners of the
door panel, 1/8" wide and 3/16" deep.
This will allow the panel to slide under
the escutcheon. The bottom corners of
the door panel trim and all 4 corners
of the access panel trim are rounded.
Therefore, for a good fit, a 5/16"
radius cut is required.
11
3
Step
Prepare
1/4" Custom
Panels
1/4" Custom Panels
Models ZBD4600X and ZBD4700X
Skip this step if you are
not using custom panels.
For Model
ZBD4600X and
ZBD4700X ONLY
1/4" Thick
Door Panel
22-11/16"
1-1/2"
23-1/4"
1/4" Thick Access Panel
5/16"
Radius
Cut
Notch 1/8"
3/16"
Insert Custom
Door Panel
• Remove 2 Phillips head color matched
screws on each side of the door trim.
• Remove 2 screws on the bottom of the door
trim.
• Slide the door trim down and remove.
• Slide the 1/4" thick custom panel under the
escutcheon lip. Making sure the panel is
centered left to right.
• Re-install the door trim using the screws
previously removed.
Important: Do not overtighten screws. Hand-
tighten with a Phillips head screwdriver.
• Remove the two screws below the access
panel assembly and lift off.
• Remove the 4 Phillips head color matched
screws on the bottom side of the assembly
and 2 screws on the top.
• Lift off the trim piece.
• Place the custom panel on top of the assem-
bly and reinstall the trim with the same color
matched screws.
• Set the assembled access panel aside. Do not
reinstall this piece until final installation is
complete.
Install Custom
Access Panel
Remove
4 Screws
Remove 2 Screws
Custom Panel