GE ZBD4800XBB, Руководство по установке

Страница: 10 / 24

10
Installation Preparation
Stainless Steel Interior Dishwashers
If you have a question concerning the installa-
tion of this product, call the GE Answer
Center
®
Consumer Information Service at
800.626.2000, 24 hours a day, 7 days a week.
If you received a damaged
dishwasher, you should
immediately contact your
dealer or builder.
Installation of this dishwasher requires basic
electrical and mechanical skills. Proper
installation is the responsibility of the installer.
Product failure due to improper installation is
not covered under the GE Appliance War-
ranty. See the back cover of the Use & Care
Guide for warranty information.
The dishwasher MUST be installed in such a
manner to allow for future removal from the
enclosure if service is required.
Before starting make sure that the custom
panel is available.
If not, the dishwasher will
have to be removed from under the counter
to install the panels.
• Tape measure
• Spirit level
• Flat blade
screwdriver
Tools
Required
(not supplied)
• Phillips
screwdriver
• Awl
• Carpenters square
• Wire cutter
• Adjustable wrench
• Wire stripper • Electric drill
• 1-1/2" drill bit
or hole saw
• Pliers
Materials
Required
(not supplied)
• Minimum 3/8" OD
copper tubing of
sufficient length for
your installation
• Shut-off valve
• Compression nut
• Compression sleeve
• 90
°
compression
elbow (3/8" NPT
one end)
• Two 1-1/4" adjust-
able hose clamps (to
accommodate drain
line)
• 120 Volt 60 Hz. 15
Amp or 20 Amp, 2
wire with ground
Properly grounded
branch circuit
• 1/2" strain relief
bushing for electri-
cal supply cable.
• 3 wire nuts
Cut the shipping carton and use it as a pad
under the dishwasher. This will protect the
finished flooring of the room.
• Remove the toekick taped to the top of the
dishwasher.
• Remove the template taped to the side (on
Model ZBD4800X only).
• Lay the dishwasher on its back close to the
opening.
• Place a 2x4 block or two corner posts from
packaging beneath the dishwasher. This
will prevent the dishwasher from falling
when the shipping bolts are removed.
• Remove 4 shipping bolts with an
adjustable wrench and discard.
2
Remove
Packaging
Step
Block