GE Transport Pro, Руководство по обслуживанию

Страница: 53 / 110

Revision A Transport Pro 6-7
2012659-042
Troubleshooting: Power Sources
Power Sources
The monitor can be powered from its two batteries, TRAM power or by an
external AC power supply. It automatically switches power sources as
they are depleted or removed.
The monitor uses the following pattern to sustain power:
1. The monitor’s external power supply.
2. The monitor’s battery power.
3. The acquisition device’s power.
It uses the internal battery with the lowest capacity to power the system
first. It only uses the acquisition device batteries to power the monitor if
there are no internal batteries or the internal batteries have capacities
too low to support proper operation.
The monitor also provides power to a acquisition device via its battery
power or external AC power source.
Service Menu
These service menus track and log information that may be helpful for
some troubleshooting scenarios.
WARNING
The Boot Loader Service Menu and the Service Mode
menu are intended for qualified personnel only. It is
possible to lose patient data and damage the operating
software for this monitor. Do not ‘experiment’ with any
service menu commands.
Qualified field engineers and factory service personnel use the service
menus to troubleshoot, repair, or download new software to the monitor.
Only persons responsible for configuring and maintaining the monitor
should access the service menus. ALWAYS use caution when using any
of these protected functions.
Refer to “General” on page 4-2 for password, Boot Loader access and
reboot instructions.