GE Profile JS968, Руководство по установке

Страница: 11 / 20

11
Installation Instructions
Installing the Range
FIG. 1
Decide whether the bracket will be
installed on the right or left side of the
range opening.
Place the bracket as shown in Fig. 1.
FIG. 2
INSTALLING THE BRACKET
IN WOOD OR CONCRETE
10
INSTALLATION—WOOD
CONSTRUCTIONS
Locate the centers of the 4 holes
identified in Fig. 1 as Floor–Wood and
Wall.
Drill a 1/8
”
pilot hole through the
pre-marked areas. Note the angle of
the wall screw in Fig. 2.
Mount the Anti-Tip bracket with the
4 screws provided.
INSTALLATION—CONCRETE
CONSTRUCTIONS
For concrete installation, you will need
two 1/4
”
x 1-1/2
”
lag screws and two
sleeve anchors.
Locate the center of the 4 holes
identified in Fig. 1 as Floor–Concrete
and Wall. Drill the recommended size
holes in each.
Install the sleeve anchors into the
predrilled concrete holes and install the
lag and wall screws through the Anti-Tip
bracket. Make sure the screws are
securely tightened.
To Front Edge
of Countertop
Bracket
Wall Plate
Screw Must
Enter Wood
or Metal
25 ”
REPLACE THE WIRE COVER
8
Replace the wire cover
(on the back of the
range) by replacing the
2 screws removed
earlier.
Wire
Cover
NOTE: When reinstalling the wire
cover, make sure that wires do not
become pinched between the wire
cover and the housing.
LOCATING THE ANTI-TIP BRACKET
9
A
B
Adjacent
Cabinet
Bracket
Side
FLOOR–WOOD
Rear
Leveling Leg
FLOOR–CONCRETE
Wall
WARNING:
Range must be secured by Anti-Tip
bracket supplied.
See instructions to install (supplied
with bracket).
Unless properly installed, the range
could be tipped by stepping or sitting on
the door. Injury may result from spilled
hot liquids or from the range itself.
A
B
C
A
B
C
(Continued on following page)