GE Optima CT670, Руководство по установке

Страница: 68 / 206

GE C
OMPANY
D
IRECTION
5472001-1EN, R
EVISION
6 O
PTIMA
CT680 S
ERIES AND
O
PTIMA
CT670 I
NSTALLATION
M
ANUAL
Page 68 Section 10.0 - Table Installation (Lite Table)
10.3.4.3 Procedure
NOTICE Avoid leaning on the cradle during this procedure.
DO NOT pin the gantry during this alignment process.
This procedure is for systems mounted on 102 mm (4 in.) concrete floors only!
Note: If the floor covering was not properly removed with the glue removed, or the levelers were not
centered over the floor cutouts, the leveler may become trapped against the edge of the floor
covering, causing the table to become unlevel. If this happens, move the table and enlarge the 102
mm (4 in.) floor cutout for the table. Glue removal is important and aids in moving the table to its
final location in accordance with the floor levelness specification.
1.) Place the bubble level on the table base . See Figure 1-47 .
Figure 1-47 Place Bubble Level
2.) Turn on the laser's "I" beam (vertical beam) by pressing the ON button 2 times.
3.) With the laser on, the laser light should shine through the front tool down the cradle connecting
the front and rear center lines and onto the center of the rear alignment tool.
4.) Raise or lower the table as needed using the two front and two rear adjusters so that this line
is shining 100% in the machined grooves of each alignment tool.( it is easier to raise, move,
and lower the table using the table dolly. This prevents the adjuster levelers from gripping on
the floor adhesive, making it difficult to move.)
a.) The light will shine vertically down the table.
b.) Both center lines on the cradle front and rear should be connected when done.
c.) Level of the table influences a center position, The vertical laser alignment light must
match and be centered on the white line on the front of the table and in the groove of back
alignment plate. See
Figure 1-48 .
Figure 1-48 Front and Rear Adjuster
5.) Be sure that all adjusters bear part of table's load.