REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT
—
Do not kick off wood base! Damage
will occur.
• Move the dishwasher close to the installation location and lay it
on its back.
• Remove the four leveling legs on the underside of the
wood base with an adjustable wrench or 15/16" socket.
• Discard base.
• Screw leveling legs back into the dishwasher frame,
approximately 1/4" from frame as shown.
STEP 2
REMOVE TOEKICK
• Remove the two toekick screws.
STEP 3
8
Toekick
Remove 2
Toekick Screws
Installation Instructions
Figure H
Approx.
1/4"
Figure J
INSTALL POWER CORD
Use Power Cord Kit WX09X70910 available for purchase from an
authorized GE Appliances dealer.
Skip this step if dishwasher will be direct wired or has a
factory installed power cord.
The power cord and connections must comply with the National
Electrical Code, Section 422 and/or local codes and ordinances.
• Maximum power cord length is 4 feet beyond the back of the
dishwasher.
• Connect incoming power cord white (or ribbed) to dishwasher
white, black (or smooth) to black and ground to dishwasher
green wire. Use UL listed wire nuts of appropriate size.
• Replace junction box cover. Be sure wires are not pinched
under the cover.
STEP 4
White
Ground
Black
Check That White, Black and
Green Dishwasher Wires Are Threaded
Thru Small Hole in Bracket
Remove
Junction Box
Cover
Insert Power
Cord Wires Thru
Strain Relief
and Tighten
Use UL Listed
Wire Nuts
A
C
B
D
Figure K
INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
• Do not overtighten 90° elbow, water valve bracket could bend
or water valve fitting could break.
• Position the end of the elbow to face the rear of the dishwasher.
STEP 5
Front of Dishwasher
90
°
Elbow
Thread
Seal Tape
Fill
Hose
Water Valve
Bracket
Figure L
