ZBD6890KII – GE Monogram Fully Integrated Built-In Dishwasher
Specification Revised 9/05
150042
Dimensions and Specifications (in inches)
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call GE Answer Center
®
service, 800.626.2000.
• The dishwasher must be installed so that the drain hose is
no more than 10 feet in length for proper drainage.
• Water and power supply should enter in the shaded area.
• Electrical and water connections are at the right front of the
dishwasher. The hot water line should extend forward 30" to
40" from the rear wall. The electrical must extend forward at
least 24" to reach the junction box.
• To prevent siphoning, an air gap must be used when the
waste tee or disposer connection is less than 18" above
the floor.
24"
min.
24"
34" to 35"
Floor to
Underside of
Countertop
24"
34" - 35"*
24"
4"
This Wall Area Must be
Free of Pipes or Wires
Plumbing and Electric Service
Must Enter Inside This Area
6"
Electrical Requirements
The dishwasher must be supplied with 120V, 60Hz, and connected
to an individual properly grounded branch circuit protected by a
15- or 20-amp circuit breaker or time-delay fuse.
R
Listed by
Underwriters
Laboratories
As an ENERGY STAR
®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
Custom Panel for Model ZBD6890KII
These dishwashers require a field installed 3/4” thick custom panel
and custom handle. An installation template is packed with these
models and may be obtained in advance.
Order Pub. No. 31-30569-1
.
Complete panel installation instructions are included on the template.
CUSTOM PANEL SIZE REQUIREMENTS
HEIGHT
Panel height must
be between
30-1/16" and 30-1/4".
• If the panel height is
more than 30-1/4” it
will prevent the door
from swinging open.
• If the panel height is
less than 30-1/16” it
will not cover the
dishwasher door frame.
• The top of the custom
panel must be flush
with the top of the door. The 1/2” minimum gap between the top of
the door and the bottom of the countertop must be maintained.
WIDTH
Panel width must be 23-3/4".
• If the panel width is less than
23-3/4” it will not cover the
dishwasher frame.
IMPORTANT: To ensure optimum
door balance performance, the
custom panel must not weigh
more than 14 lbs.
Before installing refer to installation instructions for details.
Pub. No. 31-30586
Minimum 1/2" Gap
for Clearance
Countertop
1/2" min.
23-3/4"
30-1/16" Min.
30-1/4" Max.
Minimum 1/2" Gap
for Clearance
Countertop
1/2" min.
23-3/4"
30-1/16" Min.
30-1/4" Max.
