GE LOGIQ A100, Техническая публикация

Страница: 279 / 408

Probes
263
LOGIQ
t α
100 User Manual
2211157–100 Rev 0
Probe handling and infection control
This information is intended to increase user awareness
of the risks of disease transmission associated with using
this equipment and provide guidance in making decisions
directly affecting the safety of the patient as well as the
equipment user.
Diagnostic ultrasound systems utilize ultrasound energy
that must be coupled to the patient by direct physical
contact. Depending on the type of examination, this
contact occurs with a variety of tissues ranging from
intact skin in a routine exam to recirculating blood in a
surgical procedure. The level of risk of infection varies
greatly with the type of contact.
One of the most effective ways to prevent transmission
between patients is with single use or disposable
devices. However, ultrasound transducers are complex
and expensive devices that must be reused between
patients. It is very important, therefore, to minimize the
risk of disease transmission by using barriers and
through proper processing between patients.
Adequate cleaning and disinfection are necessary to
prevent disease transmission. It is the responsibility of
the equipment user to verify and maintain the
effectiveness of the infection control procedures in use.
Always use probe sheaths for intracavitary procedures.
Probe Cleaning Process
To clean the probe:
1. After each use, disconnect the probe from the
ultrasound console and remove all coupling gel
from the probe by wiping with a soft cloth and
rinsing with flowing water.
2. Wash the probe with mild soap in lukewarm water.
Scrub the probe as needed using a soft sponge,
gauze, or cloth to remove all visible residue from
the probe surface. Prolonged soaking or
scrubbing with a soft bristle brush (such as a
toothbrush) may be necessary if material has
dried onto the probe surface.
CAUTION
After Each Use