GE KTD-400, Руководство пользователя

Страница: 10 / 28

KTD-400 Controller Keypad
User Manual
6
KTD-400 configuration
After you install and power up your KTD-400 keypad, you will need to configure it to operate within your
systems. You can also use the KTD-400 to configure other components in the Digiplex system. (See
System
component configuration on page 10.)
The KTD-400 offers many programming choices that identify how it will function in the system. A separate
code is used to access the menus. For new installations, follow the programming steps in the order they are
presented. If you need to change any programmed data at a later date, enter the appropriate programming
mode and use the designated keys to advance the menu associated with that data.
• System size (see Figure 11 on page 7)
• Camera site access (see Figure 12 on page 7)
• Monitor access (see Figure 13 on page 8)
• Multiplexer enable and select (see Figure 14 on page 8)
• Multiplexer view display (see Figure 15 on page 8)
• VCR enabled (see Figure 16 on page 9)
• Maximum presets (see Figure 17 on page 9)
• Monitor offset (see Figure 18 on page 9)
When you supply power to the unit, the LCD will momentarily display a limited amount of configuration
information on the unit (
Figure 7 ).
Figure 7. Programming display
After a few seconds, the normal operating display menu ( Figure 8 on page 6) will appear.
To configure the KTD-400, do the following:.
1. In the normal operating display ( Figure 8 ),
enter programming mode by pressing and
holding the
Set key until you see the display
in Figure 9 .
Figure 8. Normal operating display
2. At the code entry display ( Figure 9 ), enter
the access code 5 , 7 , 9 , Seq .
Figure 9. Code entry display
Largest Largest Largest Largest Monitor Key
camera monitor multiplexer VCR offset layout
Revision number
KTD-400 DDMMYY
255 64 64 64 00 0
CAMERA 000
MONITOR 01
CAMERA 000 (CODE)
MONITOR 01 (----)